The old network code spans a range from about 0.41.1 when TCP support was introduced up to the recent 1.4 series. It used variable names like STATUS, UTILITY, and LOADPCT. Many of these names go back to the earliest prototypes of this software from 1997. At that point there was no way to know that so many drivers would come along and introduce so many new variables and commands. The resulting mess grew out of control over the years.
During the 1.3 development cycle, all variables and instant commands were renamed to fit into a tree-like structure. There are major groups, like input, output and battery. Members of those groups have been arranged to make sense - input.voltage and output.voltage compliment each other. The old names were UTILITY and OUTVOLT. The benefits in this change are obvious.
The 1.4 clients can talk to either type of server, and can handle either naming scheme. 1.4 servers have a compatibility mode where they can answer queries for both names, even though the drivers are internally using the new format.
When 1.4 clients talk to 1.4 or 2.0 (or more recent) servers, they will use the new names.
Here’s a table to make it easier to visualize:
| Server version | ||||
|---|---|---|---|---|
Client version | 1.0 | 1.2 | 1.4 | 2.0+ |
1.0 | yes | yes | yes | no |
1.2 | yes | yes | yes | no |
1.4 | yes | yes | yes | yes |
2.0+ | no | no | yes | yes |
Version 2.0, and more recent, do not contain backwards compatibility for the old protocol and variable/command names. As a result, 2.0 clients can’t talk to anything older than a 1.4 server. If you ask a 2.0 client to fetch "STATUS", it will fail. You’ll have to ask for "ups.status" instead.
Authors of separate monitoring programs should have used the 1.4 series to write support for the new variables and command names. Client software can easily support both versions as long as they like. If upsd returns ERR UNKNOWN-COMMAND to a GET request, you need to use REQ.